Thanks for your posting.  We offer a straight oil/filter change using original Bombardier products for $109.68 (this is labor, oil (4 qts), oil filter, shop supplies and tax). This is not an overall unit inspection--just a basic oil change.  If this is the first time you've had your unit serviced since purchasing we recommend you invest in a 10 Hour Check for $197.87.  If you purchased your ATV from us you will receive a discount (see below)! The 10 hour check gives us a chance to go over the unit from top to bottom thoroughly.  I have posted our checklist below so you can see what you'd be paying for and also to understand why we are recommending this type of maintenance if you have not yet had it done.   You will preserve the overall life of the ATV and keep it running better for you too.  This service is performed by Bombardier-trained technicians on our staff.   If you'd like to set up an appointment you can email us at: service@burtlakemarina.com or call 238-8265.  We can offer you same-day service if you schedule your appointment for either of the next two weeks.  I recommend scheduling before the first week of May, as the schedule is already filling up for Memorial day weekend.  Hope this helps! 

ATV 10HR CHECK

Rally --$173.22    Traxter (All Models)---$197.87   

  All Outlander Models & Outlander DS 650 (except model year 2000)-$189.92

Quest (All Models) ---$188.86       DS650 (2000 only)--$187.80

*To show new customers our appreciation, units purchased from Burt Lake Marina Sales will receive $35.00 off the cost of labor!

**Synthetic Oil will be used in all oil changes unless otherwise requested.

Standard oil will decrease the cost of the 10hr check.

ELECTRICAL SYSTEM:

□Check battery condition %_____________________

□ Inspect spark plugs

□ Inspect battery connections

□Check wiring harness, cables and lines.  Secure routing.

□Check operation of ignition switch, start button and engine stop switch.

□Check headlamp beam direction


FUEL SYSTEM

□Check air filter

□Check fuel lines and connections

□Check carburetor

 □Check choke

ENGINE/TRANSMISSION

□Replace engine/transmission oil and filter

□Inspect engine mount fasteners

□Inspect exhaust system

□Check valves and adjust if needed

□Check coolant level--%_________________

□Check radiator condition/cleanliness (air ducts and radiator fins)

□Check CVT air inlet duct condition/cleanliness and sealing

STEERING SYSTEM

□Inspect throttle/housing/cable

 □Inspect steering system mechanism

□Check front wheel alignment and adjust if needed

□Check wheel nuts/studs to ensure tight

□Check tire wear and pressure

DRIVE TRAIN

□Inspect drive shaft boots and protectors

□Inspect front and rear propeller shaft joints

□Check front and rear differential oil level, seals and vents.

□Check drive chain lubrication—lube if needed

□ Check drive chain adjustment

□Inspect drive chain protector and roller condition

□Check sprockets for wear or damage

□Check wheel bearing

□Check rear wheel hub

□Check rear axle tightness (eccentric axle housing) bolts and brake hub locking
nuts

SUSPENSION

□Inspect trailing arms and bearings

□Inspect shock absorbers

□Inspect A-arms

□Inspect McPherson struts

□Inspect ball joints

BRAKES
 □    Check brake cable
 □      Check brake fluid, front and rear
 □    Inspect brake system, condition of discs, hoses, etc.
 □     Check brake pads
 
BODY AND FRAME

            □          Inspect engine area

            □          Check frame fasteners

            □          Inspect hitch/trailer ball condition (if installed)

            □          Check condition of body panels and frame.  Note any damage

 All work performed by:________________________________                    Date:_______________